Cobalt Networks openGear 9252 Manual de usuario

9252 Manual V.1.0 2/2/2009 Cobalt Digital Inc. 9252 1x8 / 1x4 AES/EBU Distribution Amplifier - 110 Ohm User Manual CDI Part Numbe

10Rear Module Options This is a drawing of the RM-9252-A rear module to be used in the 10 slot 8310-C frame only. Figure 3. Rear Module Board I

11User Controls This chapter contains a description of the 9252 user controls: • EQ Switch • LEDs . User Controls Lo c k L EDNo L o ck L E DEQ

12LEDs The front-edge of the card features LEDs that display the status of the input signals. As selections are made in the menus, (refer the subseq

13 Specifications Technical Specifications DIGITAL INPUT Resolution 24 Bit Input Level 0.2-7 Vp-p Input Impedance (transformer balanced) 75

14Warranty and Service Information Warranty and Repair Policy The openGear 9252 is warranted to be free of any defect with respect to performance, q

15 Ordering Information Standard Equipment • 9252 AES/EBU Distribution Amplifier 75 Ohm Optional Equipment • 9252OM AES/EBU Distribution Ampli

16Contact Us Contact our friendly and professional support representatives for the following: • Name and address of your local dealer • Product

29252 •••• 1x8 / 1x4 AES/EBU Distribution Amplifier - 110 Ohm, User Manual • Cobalt Digital Part Number: 9252 • Document Version: 1.0 • Printed i

3Important Regulatory and Safety Notices Before using this product and any associated equipment, refer to the “Important Safety Instruct

4EMC Notices US FCC Part 15 This equipment has been tested and found to comply with the limits for a class A Digital device, pursuant to part 15 of

5Environmental Information The equipment that you purchased required the extraction and use of natural resources for its production. It may cont

6 Introduction This chapter contains the following sections: • Overview • Functional Block Diagram • Features • Documentation Terms Overvie

7Features The following features make the 9252 the best solution for digital audio distribution. • Cable equalization and data reclocking on the in

8 Installation and Setup This chapter contains the following sections: • Static Discharge • Unpacking • Rear Module Options • Board Install

9Rear Module Installation If you are installing the card into a slot with no rear module, you should have ordered and received one of the RM-9252-A